73,K0COP
David H. Walker
Aiken, SC
k0cop@onlymyemail.com
Virus scan by BitDefender
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of john
Sent: Saturday, 11 November, 2006 17:35
To: tentec@contesting.com
Subject: [TenTec] More interface problems (OmniVI+) ...help!
To recap:
Have logger32 working fine with Elecraft K2, now with Paragon*, but still
no go with OmniVI+
Things I've verified:
There is serial data coming out of the Omni DB25 serial port. (Can see
w/scope@rs232 levels)
Remote tuning pod works on serial port of Omni
Radio is being polled for Freq and Mode (can see via the debug screen in
logger)
Tried straight serial cable, and cable w/pin 2 and 3 swapped at one end. No
difference.
Baud rate is set the same in logger and in Omni (same as K2 which works!)
Things I'm not sure of:
Does the Computer ID setting in the OmniVI+ matter, if using the DB25 port?
This is really getting frustrating. All suggestions greatly appreciated.
John K5MO
Have you tried ICOM 735 setting?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|