Excellent point on the SWR, Bob.
In fact I have never thought to monitor the SWR.
On the point with SSB and VOX being the same, yes, good point but it's not
nearly as bad on the radio as CW.
Normally when the SSB VOX triggers, it's the beginning of a word and voice
will typically start soft and ramp up in volume. Therefore the level of RF
hitting the relay is not yet 100w.
With CW, the full 100w is there with the first dit, immediately - (well
almost immediately, depending on the rise time of the signal, which is
usually about 5mS - adjustable on some of the Ten-Tecs).
However when in VOX mode, we generally work with a hang time delay, so the
RF only hits the relay too soon for the first "ahhhh", then the relay stays
switched in TX mode. Not so with CW. With CW there is no automatic hang
time (on the Eagle), adjustable hang time on the Orion and Omni VII "if and
only if" you turn it on in the menu.
So CW is beating (burning) the hell out of the non QSK relay again and again
and again under these conditions.
73 - Rick, DJ0IP
(Nr. Frankfurt am Main)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Bob McGraw
- K4TAX
Sent: Tuesday, March 18, 2014 1:27 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] QSK or not?
The biggest problem, as I understand, comes from operators using a non QSK
qualified amp in a QSK mode. At this point one can expect relay failure due
to hot switching.
As most amps do have the provision for monitoring SWR I suggest monitoring
the SWR indication for an indication of hot switching. After tune up
typically one will have low SWR.. If during keying one observes a higher
SWR value they can be assured that hot switching is taking place within the
amp. If this is the case, be assured the relays are taking a beating
electrically and will likely soon need attention.
Do note the same situation when operating VOX. Most radios provide some
degree of key-up delay when in CW but there is typically no delay during SSB
operation. Thus when the voice activates the VOX there is RF applied to the
amp without any delay. I find this to be a sure bet for realy hot
switching.
73
Bob, K4TAX
----- Original Message -----
From: "GARY HUBER" <glhuber@msn.com>
To: "TenTec Reflector" <tentec@contesting.com>
Sent: Monday, March 17, 2014 10:39 AM
Subject: [TenTec] QSK or not?
I operate QSK and have the past thirty years using TenTec equipment.
One reason given by others for not running QSK is that the relays wear out
sooner in the transceiver and amplifier.
from http://www.ad5x.com/images/Presentations/QSKals500als600RevA.pdf
How Long will the Relays Last?
What kind of life can you expect from the relays? The relay life is
specified at 100
million operations minimum at 36,000 operations/hour. The service life
increases as the
operations/hour decreases. So let's use the standard PARIS text that is used
for
determining code speed.
PARIS has 10 dits and 4 dahs = 14 relay operations/minute at 1 WPM.
Assuming an average of 25WPM code speed, you would have 360 relay operations
per
minute. So, 100 million operations = 4630 hours. Now you normally operate
50%
transmitting and 50% receiving during a QSO, so your relay operating time
should
double to 9260 hours. There are 8760 hours/year, which means you could
operate 1.057
years at 25 WPM before the relays exceeded their lifetime spec - IF you
operate 24
hours/day! But when you operate, you are probably listening more like 75% of
the time
and in a QSO 25% of the time. So this says that your relay operating life
will be over 4-
years if you operate 24 hours/day. So what do you normally average in
operating
time/day? I bet it is not more than about an hour/day. But let's say you
average 4-
hours/day of operation (i.e. you are not married and have no kids, you don't
shop or eat
or sleep much, and you don't hold a full-time job). So the relay life will
extend to about
25 years! The bottom line - Don't worry about wearing out the relays anytime
soon.
73 ES DX,
Gary - AB9M -...-.-
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|