How silly of me! Obviously the TT "dongle" has no pin 7. It's a 5 pin DIN.
You have to make up a new DIN plug, as you can see from previous posts. Not
a hard thing, of course, but be careful if you're going to maintain the
integrity of the audio lines, pins 1, 4 and 6 which should be shielded. Your
"new" plug may look a bit funny, unless you can find some 8 wire stuff with
three shielded pairs (assumes a common ground I suspect), at least that what
Stan at TT told me. How would one go about that, anyhow?
While pin 5 currently has NC, it would be wise to at least make provision
for its future use in your connector and then not connect it on the far end.
Larry, N0XB
----- Original Message -----
From: "Larry Menzel" <retire@means.net>
To: <na9u@arrl.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Sunday, February 19, 2006 8:54 AM
Subject: Re: [TenTec] Question about FSK with Orion II
> He wouldn't have to mess with the socket, John, just open the DIN plug and
> move the wire from pin 5 to pin 7. That would work fine.
>
> Larry
> ----- Original Message -----
> From: "John Nason / NA9U" <na9u@arrl.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Sunday, February 19, 2006 7:08 AM
> Subject: Re: [TenTec] Question about FSK with Orion II
>
>
>>I would speculate that they either found a cable
>> vendor that made the cable that way or they are trying
>> to use the cable for several different
>> rigs/applcations. It's your rig and you do what you
>> want to it but I would just make up a cable rather
>> than tamper with the socket.
>>
>> 73,
>> John NA9U
>>
>> --- CaseKE@aol.com wrote:
>>
>>> I would like to use the Auxiliary I/O plug and cable
>>> sent with the Orion II
>>> without modification if possible. The I/O socket is
>>> 8-pin and the plug is
>>> 5-pin. Pin 5 of the socket is a "no connection
>>> (NC)," but pin 5 of the plug does
>>> have a wire connected to it (Red). FSK is
>>> available on pin 7 of the socket,
>>> but there is no pin 7 of the plug (does this strike
>>> anybody else as strange?).
>>> Can I simply put a jumper from pin 5 of the socket
>>> to pin 7 of the socket
>>> (or alternatively rewire pin 7 to pin 5) so I have
>>> FSK on pin 5 of the supplied
>>> plug and cable?
>>>
>>> Thanks, Ken K5KC
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|