TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] Code Speed

from [John Vickers] [Permanent Link][Original]
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Code Speed
From: "John Vickers" <wa4tt@nlamerica.com>
Reply-to: John Vickers <wa4tt@nlamerica.com>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 17 Jan 2007 22:00:02 -0500
List-post: <mailto:tentec@contesting.com> 
----- Original Message ----- 
From: "John T. Fleming" <W3GQJ@earthlink.net>

> It is easy to take care of the CW when on SSB.  Just set the auto-notch to
> 9!

Not if I'm on my old unstable homebrew rig. That auto-notch'll "nut up" 
trying to figure out where the carrier's comming from next !!
73, WA4TT

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  [TenTec] HIGH SPEED SWEEP, Rich McCabe
Next by Date:  [TenTec] Omni VII on TenTec web site, Mark Kachel
Previous by Thread:  Re: [TenTec] Code Speed, jerome schatten
Next by Thread:  Re: [TenTec] Code Speed, Bwana Bob
Indexes:  [Date] [Thread] [Top] [All Lists]