I had many suggestions to reseat the cables. I did this, including a slight
twist on all the small coax cables on the top chassis, the bottom chassis, and
the front panel. Also tried flexing the panel (just a little bit). Absolutely
no reaction.
Sub receiver works well. Main receiver acts as if no antenna is attached, BUT
the sweep (with the latest beta firmware) indicates normal signals so signals
must be entering the main receiver. Transmitter is OK. (Problem started before
installing the latest firmware, so that is not the problem.)
Master reset did not solve the problem, either.
Rats.
Bill - W2WO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|