Roger Carl; actually I thought it might have been you.
I just couldn't remember.
See you in about 4 weeks.
73,
Rick, DJ0IP
(Nr. Frankfurt, Germany)
-----Original Message-----
From: TenTec <tentec-bounces@contesting.com> On Behalf Of Carl Moreschi
Sent: 09 June 2018 19:31
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] "FIX" for Orion-1 / ACOM Amp "ARC-FAULT" Problem
Hi Rick,
That was me. But I no longer have the Acom.
See you in Germany.
73
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 6/9/2018 9:40 AM, Rick@dj0ip.de wrote:
> Long forgotten, and today I stumbled upon my old notes and even a
> choke for fixing the problem.
> I have uploaded this MOD to my web site:
>
> http://www.dj0ip.de/ten-tec-stuff/orion-acom-fix/
>
> I couldn't find the exact value of the choke and it is probably not
> too critical.
> I measured the one I had and found it to be 43 uH.
>
> A few years back, someone asked me about this mod.
> I searched for hours and hours and could not find it.
> I contacted Jack Burchfield.
> He couldn't remember the details either.
>
> So here they are; perhaps Barry can add this to the WiKi.
>
> 73,
> Rick, DJ0IP
> (Nr. Frankfurt, Germany)
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|