TRlog guys - I'm still having PCMCIA woes - please read:
>Did you try the System Soft Card and Socket Services recommended by Quatech?
>73, Yngvi TF3YH
Thanks Yngvi, I was not aware Quatech recommends System Soft software. I have
two different sets of card and Socket Services software (CardWare and CardSoft)
and neither one is getting the job done yet. I have found where all the
addresses are in the computer and the card, and I am now trying to get them all
to agree on using the same addresses - I hope that does it! So far I haven't
been able to manipulate them. Still working on it. The fact that the computer
recognizes the PCMCIA card I think means the card and socket services software
is working right, except that I can't seem to get the addresses adjusted in the
PC. Also, TRlog has a command line instruction that shows the port addresses,
but I can't get TRlog to use a different port address than what it shows. I
wonder if that part of TRlog is not working, because I think it gives you a
"change" option but when I use it nothing changes or the computer freezes, I
forget which.
Thanks - Mark, N5OT
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|