Steve, I suggest you carefully re-read the rule.
1. Nowhere does the rule say you can not use a 200 watt transceiver,
only that you can not use an external amplifier and you must keep the
power to 100 watts or less.
2. Just because I run an amplifier capable of a KW does not mean I am
driving it that hard. I can easily throttle back my transceiver to
limit the amp to 100 watts or less output.
To show how dumb this rule is, think about this. Suppose I homebrew a
KW transceiver and put it all in one cabinet. According to the rules,
that is legal as long as I keep the power down to 100 watts or less.
But suppose I build the exact same transceiver but put it in two
cabinets? Now it is illegal according to the rules. Does that make any
sense?
This rule was not well thought out and should be rescinded.
Bill W6WRT
------------ ORIGINAL MESSAGE ------------(may be snipped)
On Thu, 26 Feb 2015 11:31:00 -0500, you wrote:
>
>The RULE is a good rule.
>It limits "you" to the barefoot rating of your 100 watt rig (also means
>you can not use a 200w rig).
>Yes, it means if I want to run using my IC-706 I may need to run at 40
>watts. Short bursts may allow more.
>I does mean when I was looking for a RTTY rig, I chose an Orion with the
>optional fan (mounts on heatsink) and I can run 100w.
>the 3db "extra" I have doesn't make up for the fact I am running with a
>vertical (other then I don't need to swing the antenna for qso).
>
>IF "you" used the KW amp, "you" would be running more then 100w at
>sometime...
>
>73, steve WB3LGC
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|