Thanks gents... The resistors I am using are 10 M, 20KVs. I will build
a small chassis and put them on inside, with a pair of SO-239s.
73, and thanks,
Dave (NK7Z)
https://www.nk7z.net
ARRL Volunteer Examiner
ARRL Technical Specialist, RFI
ARRL Asst. Director, NW Division, Technical Resources
On 9/17/21 6:25 PM, Jim Brown wrote:
On 9/17/2021 5:54 PM, David Eckhardt wrote:
The value is anything over 10 kohms. The disturbance
to the 50-ohm impedance is completely negligible. The rule-of-thumb
on the
resistor value is something over 10X the system impedance. I've even
used
1k successfully.
A limiting factor for low values is dissipation in the bleed resistor.
73, Jim K9YC
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|