Re: [Karlnet] KN with externally controlled STP

[Roger Boggs <rogerboggs@att.net>]

Setup|Bridge Setup|Advanced Features|Enable Learned Table Lockdown?

Then reboot, and it should remain pretty stupid, shouldn't it?

At 09:36 PM 6/3/03 +1200, you wrote:
> Has anyone used KN bridge's (RG's in point-point mode) in an STP scenario?
> (triangle loop to be precise)
> We need to use STP enabled switches rather than the KN onboard STP feature.
> KN's STP works fine on its own, however when disabled and the switches are
> added - the entire combo crashes and burns.
> When replaced with cat5 cable on the test bench it works fine.
> Im guessing this is due to the fact that Karlnet'd RG's are learning
> bridges.
>
> Is there any way to turn off the learn feature thus creating a wireless link
> as-close-as-you-can-get to a length of dumb cat5 cable?
>
> -Sam

Roger Boggs