Norm
This is correct, I believe Doug posted this is other day. TC does not
report noise level as the firmware on all Prism cards do not report it
yet. From what I have been told the card can do it if the firmware is
change seems like a simple request, still looking into this.
In the mean time we put in a request to grey out the s/n and noise
readings as not to confuse things.
Sincerely
Tony Morella
Demarc Technology Group
Office: 908-996-7995
Cell: 908-246-9170
Fax: 908-847-0202
email: tony@demarctech.com
http://www.demarctech.com
Wireless Solution Provider
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
On Behalf Of Norm Young
Sent: Saturday, June 22, 2002 11:45 PM
To: karlnet@WISPNotes.com
Subject: [Karlnet] 100 mW PRISM card do not report signal or noise
w/TC...
Tony, I tried your 100mW PRISM 2.5 cards in TC v4.02/AP-1000/SA-4400,
and while the signal gains at the CPE's were impressive (7-8dB reported
from the CPE Orinoco radio on average), the reporting from the PRISM 2.5
card was, well, non-existent. All of my CPEs are reported to have a S/N
of 1, signal -94, noise, -95. Obviously bogus, obviously not reported
correctly by the card, or correctly interpreted by Karlnet TC.
Norm
----- Original Message -----
From: "Tony " <tonylist@wwwbiz.com>
To: <karlnet@WISPNotes.com>
Sent: Saturday, June 22, 2002 8:38 AM
Subject: RE: [Karlnet] AP1000 with non-lucent cards
> Larry
>
> This is correct at this time, I have not received a update on whether
> or not SEC will be supported on the Prism chip. Doug any comments on
> this??
>
> Sincerely
> Tony Morella
> Demarc Technology Group
> Office: 908-996-7995
> Cell: 908-246-9170
> Fax: 908-847-0202
> email: tony@demarctech.com
> http://www.demarctech.com
> Wireless Solution Provider
>
>
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
> On Behalf Of Larry Yunker
> Sent: Friday, June 21, 2002 9:24 PM
> To: karlnet@WISPNotes.com
> Subject: RE: [Karlnet] AP1000 with non-lucent cards
>
>
> So you are stating that you can't even run 100mw cards in SEC mode in
> a PC running a karlnet flash-rom kit? This sounds worse than I had
> thought. I was really hoping to stay with Karlnet for it's nice
> client signal monitoring capability. But I really need to get cards
> with more juice than 35mw and I really DON'T want to resort to AMPs.
>
>
> ---------- Original Message ----------------------------------
> From: "Tony " <tonylist@wwwbiz.com>
> Reply-To: karlnet@WISPNotes.com
> Date: Fri, 21 Jun 2002 20:06:08 -0400
>
> >Larry
> >
> >Your request is for SEC which is not an option under the prism cards,
> >SEC only works for Orinoco cards.
> >
> >Sincerely
> >Tony Morella
> >Demarc Technology Group
> >Office: 908-996-7995
> >Cell: 908-246-9170
> >Fax: 908-847-0202
> >email: tony@demarctech.com
> >http://www.demarctech.com
> >Wireless Solution Provider
> >
> >
> >-----Original Message-----
> >From: karlnet-admin@WISPNotes.com
> >[mailto:karlnet-admin@WISPNotes.com]
> >On Behalf Of Larry Yunker
> >Sent: Friday, June 21, 2002 4:33 PM
> >To: karlnet@WISPNotes.com
> >Subject: RE: [Karlnet] AP1000 with non-lucent cards
> >
> >
> >Hmm... I could have sworn that there were a few guys that had the
> >AP-1000's running in Turbocell mode with the prism cards.
> >
> >Here is what I need:
> >
> >Some sort of hardware suitable for tower mounting (lightweight,
> >weather
>
> >resistant, Power-over-ethernet, etc, etc)
> >
> >Karlnet SEC BASE
> >three 100mw Cards (to run 3 sector antennas)
> >one standard 35mw Lucent Silver/Gold Card (to run backhaul to NOC
> >cross-polarized and 25ft vertical separation from the sectors)
> >
> >Does anyone market a 4-PCMCIA-slot SBC's with Karlnet firmware? Or
> >maybe I'll just need to get two 2-PCMCIA slot SBC's with Karlnet.
> >
> >Anyway... if Karlnet has any suggestions or if any vendors would like
> >to contact me off-list, I'm looking for a solution!
> >
> >Thanks,
> >Larry
> >
> >
> >---------- Original Message ----------------------------------
> >From: "Support" <support@karlnet.com>
> >Reply-To: karlnet@WISPNotes.com
> >Date: Fri, 21 Jun 2002 15:47:59 -0400
> >
> >>The higher output radios don't work in the AP-1000. The hardware
> >>isn't
> >
> >>setup to handle the power.
> >>
> >>Doug Harman
> >>KarlNet, Inc.
> >>525 Metro Place North
> >>Suite 100
> >>Dublin, OH 43017
> >>614 822-5275 x 123
> >>614 822-0024 fax
> >>
> >>> -----Original Message-----
> >>> From: karlnet-admin@WISPNotes.com
> >>> [mailto:karlnet-admin@WISPNotes.com]On
> >>> Behalf Of Larry Yunker
> >>> Sent: Friday, June 21, 2002 11:25 AM
> >>> To: karlnet@WISPNotes.com
> >>> Subject: [Karlnet] AP1000 with non-lucent cards
> >>>
> >>>
> >>> Has anyone had any luck running the AP1000 in 802.11b mode with
> >>> non-lucent cards. I'm hoping to find a 100mw solution, but it has
> to
> >
> >>> be 802.11b mode NOT Turbocell.
> >>>
> >>> Does the Karlnet SEC Base software let me do this?
> >>>
> >>>
> >>> _______________________________________________
> >>> Karlnet mailing list
> >>> Karlnet@WISPNotes.com
> >>> http://lists.wispnotes.com/mailman/listinfo/karlnet
> >>>
> >>
> >>_______________________________________________
> >>Karlnet mailing list
> >>Karlnet@WISPNotes.com
> >>http://lists.wispnotes.com/mailman/listinfo/karlnet
> >>
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> >_______________________________________________
> >Karlnet mailing list
> >Karlnet@WISPNotes.com
> >http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|