Currently its NOT selected, but what does that do when you inhibit nat
on the 802.11b interface?
Dan Metcalf
Wireless Broadband Systems
http://www.wbsysnet.com/
877-685-0578
dan.metcalf@wbsysnet.com
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
On
> Behalf Of Nate McLain
> Sent: Tuesday, September 17, 2002 9:55 AM
> To: karlnet@WISPNotes.com
> Subject: RE: [Karlnet] NAT SETTING - INHIBIT NAT FROM INTERFACE ? what
> does it do?
>
> We always inhibit NAT on the 802.11 interface I believe.
> Is that what your doing?
>
> Nate
>
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com
[mailto:karlnet-admin@WISPNotes.com]On
> Behalf Of Dan Metcalf
> Sent: Tuesday, September 17, 2002 8:37 AM
> To: karlnet@WISPNotes.com
> Subject: RE: [Karlnet] NAT SETTING - INHIBIT NAT FROM INTERFACE ? what
> does it do?
>
>
> NO I don't have bridging selected!
>
> Dan Metcalf
> Wireless Broadband Systems
> http://www.wbsysnet.com/
> 877-685-0578
> dan.metcalf@wbsysnet.com
>
>
> > -----Original Message-----
> > From: karlnet-admin@WISPNotes.com
[mailto:karlnet-admin@WISPNotes.com]
> On
> > Behalf Of Nate McLain
> > Sent: Tuesday, September 17, 2002 9:28 AM
> > To: karlnet@WISPNotes.com
> > Subject: RE: [Karlnet] NAT SETTING - INHIBIT NAT FROM INTERFACE ?
what
> > does it do?
> >
> > Do you have Enable Bridging checked along with Incoming & Outgoing
> NAT???
> > If so you will be bridging your private IPs. And it might appear to
be
> a
> > leaky NAT...
> >
> > Nate
> >
> >
> > -----Original Message-----
> > From: karlnet-admin@WISPNotes.com
> [mailto:karlnet-admin@WISPNotes.com]On
> > Behalf Of Dan Metcalf
> > Sent: Tuesday, September 17, 2002 7:44 AM
> > To: karlnet@WISPNotes.com
> > Subject: RE: [Karlnet] NAT SETTING - INHIBIT NAT FROM INTERFACE ?
what
> > does it do?
> >
> >
> > This option is under outgoing nat setup, we are having a problem
with
> > v4.02 and NAT leaking through. I'm wondering if this setting has
> > anything to do with it?
> >
> > Does anybody know what this setting does?
> >
> > Dan Metcalf
> > Wireless Broadband Systems
> > http://www.wbsysnet.com/
> > 877-685-0578
> > dan.metcalf@wbsysnet.com
> >
> >
> > > -----Original Message-----
> > > From: karlnet-admin@WISPNotes.com
> [mailto:karlnet-admin@WISPNotes.com]
> > On
> > > Behalf Of nate
> > > Sent: Monday, September 16, 2002 9:48 PM
> > > To: karlnet@WISPNotes.com
> > > Subject: Re: [Karlnet] WavePoint - II E ???
> > >
> > > I will give it a try.
> > > I wouldn't think it would be that picky...
> > > But I did try lots of different ways and timing when i was trying
to
> > get
> > > it
> > > into base boot mode.
> > >
> > > I will give this one a try as well.
> > >
> > > Nate
> > >
> > >
> > > > Hello Nate,
> > > >
> > > > The WPII are picky about the order and timing of pressing the
> reset
> > > > and reload buttons.
> > > >
> > > > Press the reset and when the "PC card B" LED turn orange, quite
> > > > quick, rrelease the reset and press the reload untill the power
> led
> > > > is oraange.
> > > >
> > > > good luck
> > > >
> > > > Rod
> > > >
> > > > Monday, September 16, 2002, 6:17:43 PM, you wrote:
> > > >
> > > > NM> Has anyone else had any problems flashing the WP-II E??
> > > > NM> I just tried to flash 2 of these and they both act the same
> > way....
> > > >
> > > > NM> You can read them with the configev program.
> > > > NM> Get your license, Open config file, select the .bin file.
> > > > NM> Scan for the radio. Change the IP of the WPIIE to a IP in my
> > subnet.
> > > > NM> Upload the software.
> > > >
> > > > NM> Let the AP reboot and then your hosed...
> > > > NM> You can never scan it and you never get another network
> > > > connection to it...
> > > >
> > > > NM> I tried doing a forced reload as described in the pdf file
and
> I
> > > > can't ever NM> get it into base boot mode... The power led
always
> > > > goes to green. And no NM> network connection.
> > > >
> > > > NM> Can someone shed some light on this problem?
> > > >
> > > > NM> TIA
> > > >
> > > > NM> Nate
> > > >
> > > > NM> _______________________________________________
> > > > NM> Karlnet mailing list
> > > > NM> Karlnet@WISPNotes.com
> > > > NM> http://lists.wispnotes.com/mailman/listinfo/karlnet
> > > >
> > > > --
> > > > Best regards,
> > > > A. mailto:things@mail.chiriqui.com
> > > >
> > > > _______________________________________________
> > > > Karlnet mailing list
> > > > Karlnet@WISPNotes.com
> > > > http://lists.wispnotes.com/mailman/listinfo/karlnet
> > >
> > >
> > > --
> > > Open WebMail Project (http://openwebmail.org)
> > >
> > > _______________________________________________
> > > Karlnet mailing list
> > > Karlnet@WISPNotes.com
> > > http://lists.wispnotes.com/mailman/listinfo/karlnet
> > > ---
> > > [This E-mail scanned for viruses by Declude Virus]
> >
> >
> > ---
> > [This E-mail scanned for viruses by Declude Virus]
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> >
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> > ---
> > [This E-mail scanned for viruses by Declude Virus]
>
>
> ---
> [This E-mail scanned for viruses by Declude Virus]
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> ---
> [This E-mail scanned for viruses by Declude Virus]
---
[This E-mail scanned for viruses by Declude Virus]
|