if the first parameter on the 3c509 command line is for it's software
interrupt i recommend changing it to 0x6f. 0x60 is used by the dvp and
may cause confusion within ct. also, you should only need the first
parameter on the nettsr command line if you want to emulate com4.
setting the broadcast address and mask should only be needed if you have
to share the cable with some other network that doesn't like the
defaults.
when the packet driver loads what does it report? they usually spew out
a bunch of stuff about what they are and the card they are set for. in
some laptops you may need to load a driver for the pcmcia interface, i
seem to remember a driver called 'pccardgo' or some such animal that had
to be run before loading drivers for the pcmcia card itself.
Darrell Neron wrote:
>
> Hi,
> Could anyone using a 3COM pccard on a laptop please send me the command
> line they use to configure the LAN card and start CT?
> I keep getting "no packet driver found". The 3com card has a card
> configuration utility called fmenable.com for use in DOS.Then I use the
> 3c509.exe packet driver and set it up like the K1TTT instructions.
>
> I have the following lines in my bat file.
>
> fmenable IRQ=5 COM=4 (default address reads 300h)
> 3c509 0x60 0x300 0xc000
> nettsr 10.0.0.1 100 255.255.255.0 9870 10.0.0.10
>
> Anything obvious that I am doing wrong? Any help appreciated.
> 73 Darrell AB2E
>
> --
> Submissions: ct-user@contesting.com
> Administrative requests: ct-user-REQUEST@contesting.com
> WWW: http://www.contesting.com/ct/
> Questions: owner-ct-user@contesting.com
--
David Robbins K1TTT (ex KY1H)
k1ttt@berkshire.net or robbins@berkshire.net
http://www.berkshire.net/~robbins/k1ttt.html
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|