for abt $150 plus a few misc parts i have made a programmable controller
for the yaesu g-xxxx rotor series. (yaesu's board lists for abt $350).
what i don't know is what are the commands that get sent from the
computer to the rotor? anyone have the protocol?? this controller not
only talks rs-232, but could have probably 16-20 preset's (if you wanted
that many switches). I also think that with the addition of a couple
small relays it could control just about any rotor the same way. anyone
interested in such a beast???
73, dave
--
ky1h@berkshire.net or robbins@berkshire.net
http://www.berkshire.net/~robbins/ky1h.html
--
Submissions: ct-user@ve7tcp.ampr.org
Administrative requests: ct-user-REQUEST@ve7tcp.ampr.org
WWW: http://www.ve7tcp.ampr.org/Software/ct
Questions: owner-ct-user@ve7tcp.ampr.org
|