CQ-Contest
[Top] [All Lists]

Re: [CQ-Contest] HyGain BN4000 Balun Question

To: <cq-contest@contesting.com>
Subject: Re: [CQ-Contest] HyGain BN4000 Balun Question
From: "David J. Sourdis" <hk1kxa@hotmail.com>
Date: Thu, 7 Aug 2008 21:58:54 -0500
List-post: <cq-contest@contesting.com">mailto:cq-contest@contesting.com>
Jim, 

In this link:

http://www.hy-gain.com/man/pdf/BN-4000B.pdf

Read the note under figure No. 3

Strange, if it is just beads around a piece of coax. 

David  
HK1KXA
EC5KXA


> Date: Wed, 6 Aug 2008 23:08:14 -0400
> From: k8cc@comcast.net
> To: n3bb@mindspring.com
> CC: cq-contest@contesting.com
> Subject: Re: [CQ-Contest] HyGain BN4000 Balun Question
> 
> Jim George wrote:
> > We will almost certainly be replacing a HyGain BN4000 one-to-one balun here 
> > shortly with a WX0B one-to-one balun. It is important to get the "center 
> > conductor" connected to the same half-element of the driven element in 
> > order to maintain polarity and phase in a stacked yagi system of 205CAs. 
> > Can one use an Ohmmeter to check which output lead of a BN4000 goes to the 
> > center conductor of the PL259 and which lead to the shield?
> >
> > Jim George
> > N3BB
> >
> >
> > _______________________________________________
> > CQ-Contest mailing list
> > CQ-Contest@contesting.com
> > http://lists.contesting.com/mailman/listinfo/cq-contest
> >
> >
> >   
> Jim,
> 
> A lot of modern baluns are nothing more than ferrite beads strung on a 
> length of coax inside the case.  Those can be phase tested easily with 
> an ohmmeter.  But then again, some baluns are not.  I use Radio Works 
> baluns on my 5/5/5 15M and 5/5 20M stacks, and while I've never opened 
> one of these baluns up to examine the internal design, the ohmmeter test 
> seemed to work fine to get the phase right (i.e. feedline center 
> conductor continuity to one side, shield to other, and no measurable 
> resistance between).
> 
> Maybe I'm paranoid, but I'd replace the baluns on both 205CAs rather 
> than trying to match the phase between two dissimilar baluns.
> 
> The modern baluns just work better and last longer.  I've blown up my 
> share of HyGain baluns over the years, particularly after the power 
> limit went from 1KW input to 1.5KW output in 1983 :-(  Never blown up a 
> balun here at K8CC :-)
> 
> 73,
> 
> Dave
> 
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest

_________________________________________________________________
Connect to the next generation of MSN Messenger 
http://imagine-msn.com/messenger/launch80/default.aspx?locale=en-us&source=wlmailtagline
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest

<Prev in Thread] Current Thread [Next in Thread>