I have used 4:! balun as you are contemplating
and I have also used a length of coax soldered
directly to the 450ohm open feeder line. A 1:1
balun between coax and open wire feeder would
be okay, too.
de Joe, aa4nn
> Am considering using a balun to convert the 450 ohm ladder line feed on my
> 160-30 mtr inverted V antenna to coax to just get the feed line into the
> shack. It appears that both DX-Engineering and Array Solutions make
> products specifically for this purpose, allowing you to use a short length
> of coax from the balun to the "in shack" antenna tuner. In other words, I
> would mount this balun on the outside of the house at the point where the
> ladder line enters the shack, then use RG-213 or equivalent coax to run
> from the balun to the tuner at the station (15 feet or less).
>
> Here's the question: DX-Engineering recommends using a 1:1 Balun, PN
> DXE-BAL050-H10-AT. On the other hand, Array Solutions recommends their
> 4:1 balun, AS-200-T.
>
> Has anyone used either of these baluns in this application and what
> success have you had with them ?
>
> Thanks and 73,
> Dave, K2DP, St. Louis
>
_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware
|