[AMPS] source of remote drive motors

[Ian White, G3SEK" <g3sek@ifwtech.com (Ian White, G3SEK)]

Peter Chadwick wrote:
>
>A decent workshop makes the whole job easy, especially
>a milling machine - although a lot of milling it can be very time consuming, as
>G3SEK will testify.
>
I hereby so testify. Took a looong time to remove all the aluminum I
didn't want, to leave behind the very little that I did. Peter was very
patient...

73 from Ian G3SEK          Editor, 'The VHF/UHF DX Book'
                          'In Practice' columnist for RadCom (RSGB)
                           http://www.ifwtech.com/g3sek

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com