I seen some large snap rings used once. They went around the O.D. of the
fins. A smaller one could be used on the anode cap if a fitting size could
be found. One last way was using large fuse clips on the anode connectors.
They work pretty darn good too.
Will
On Sat, 05 Feb 2005 21:35:23 -0800, Bill Turner <dezrat1242@ispwest.com>
wrote:
On Sat, 05 Feb 2005 20:51:29 +0000, Mark Hill wrote:
When it came to
connect to the valve tops, he drilled a hole in each the anodes and used
four screws.
___________________________________________________________
Ok heart, you can start beating any time now... :-)
--
Bill, W6WRT
--
Using Opera's revolutionary e-mail client: http://www.opera.com/mail/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|