AB Electronics in South Wales UK will make and supply one to your exact
requirements - they're on the web!
Paul
In message <NEBBIILMHJHGGLCPIBHAMEIOCHAA.ea6nb@wanadoo.es>, =?iso-
8859-1?Q?Jaime_P.Ull=EDvarri?= <ea6nb@wanadoo.es> writes
>
>
>This is a good idea, but where to find a 100K, pull on / push off /
>potentiometer ? I have seen them in some Heathkits kits but not in Spain.
>73, Jaime EA6NB.
>
>*-----Mensaje original-----
>*De: owner-amps@contesting.com [mailto:owner-amps@contesting.com]En
>*
>*The SB220 should ALWAYS be started in the CW position to limit inrush
>*current. NEVER start the SB220 in the SSB position, as it puts too much
>*strain on components.
>*
>*The best idea yet was to take the pot, remove it, and replace it
>*with a pull
>*on / push off / potentiometer. This will allow you to still adjust the
>*sensitivity of the meter as well as give you an operate standby
>*switch, AND
>*keep the amp looking stock.
>*
>*
>*Hope this helps.
>*
>*
>*Toll Free
>*
>*
>*_________________________________________________________________
>*Get your FREE download of MSN Explorer at http://explorer.msn.com
>*
>*
>*--
>*FAQ on WWW: http://www.contesting.com/FAQ/amps
>*Submissions: amps@contesting.com
>*Administrative requests: amps-REQUEST@contesting.com
>*Problems: owner-amps@contesting.com
>*
>*
>
>
>--
>FAQ on WWW: http://www.contesting.com/FAQ/amps
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>
>
--
To try and not succeed is better than not to try at all (Anon)
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|