This is generally good advice. However, as Manfred nicely pointed out,
"...applying an ultra thin, even layer is almost a guarantee for entrapping
air bubbles. And that's definitely worse than a thick grease layer!".
I fully agree with Manfred. It depends on the viscosity of the grease,
whether it's thin enough to be easily squeezed out by applying pressure.
73, Mike
www.w0btu.com
On Sat, Apr 11, 2015 at 9:21 AM, Kevin Stover <kevin.stover@mediacombb.net>
wrote:
>
> If after securing the transistor to the heat sink or heat sink to a
> processor you see heatsink compound oozing out the sides you've used waaay
> to much.
>
> The layer of heatsink compound needs to be an even layer almost thin
> enough to see through, with NO air bubbles.
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|