Sir,
May I post the following message on amps web page?
questions on linear amps: 1. What is your opinion on
porcelain plate caps for use in high power amps. I
always liked the way they looked, but am not sure how,
electronically, they compare to none porcelain types?
2. On the Hammarlund HXL-ONE, no center tap is on the
filament xformer, so can one put a 220 ohm, 1 watt
resistor from each lead of the secondary winding to
groung, as I have seen on similar linear using 811As?
3. I have a schematic for a Linear using 811As, so
can one use this same input circuit, "tuned L
network," using same value components, for the input
circuit on this Hammarlund? I may wire up an input
circuit same as found on the 811A amp., if you think
it will work. Best, Jack Sullivan
<P> </P>
____________________________________________________________________________________
Moody friends. Drama queens. Your life? Nope! - their life, your story. Play
Sims Stories at Yahoo! Games.
http://sims.yahoo.com/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|