What you need is the UG-646/U connector. This connector has a male (like a
PL-259) on one side and a female (like SO-239) on the other side. However, be
VERY careful in what brand you purchase. Many of the "cheaper" brands use a
coiled wire (basically a "spring") for the center conductor. The more
expensive brands use solid rod. The spring type can cause problems at
frequencies above around 30 MHz.
Glen, K9STH
Website: http://k9sth.com
--- On Sun, 11/22/09, RICHARD SOLOMON <w1ksz@q.com> wrote:
I need to make a Right Angle bend coming out of a 6 Meter SB-220. Is there a
UHF Right Angle bend I could use or should I just make extra room for the coax
curve ? The Right Angle UHF would make the installation neater.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|