Greetings:
I am considering building this amplifier for a project here. The available
information is a little light on the design of the mounting ring assembly
for the Grid. I would like to get in touch with someone who has built one
of the PA3CSG design and has direct knowledge of a working design for the
grid mounting assembly. The assembly looks like two plates with four
aluminum standoffs providing about 1 cm or 3/8 of an inch for the air
flow. The PA3CSG documentation is not clear (to me in any case) on the
exact design to use for the grid mount.
If anyone has additional information on this subject please get in touch
via direct email.
If there is a better forum for this inquiry I would also appreciate that
information as well.
Larry
VA3LK
|