I recently bought an "as is" Heathkit HA - 10 Warrior. The amp is in good
overall condition, but I'm having a problem that has me stumped. Here is a
little background........ The amp has relays installed for transmit / receive
switching and standby bias switching. The standby bias is around -75v and the
bias during transmit is -7v. The plate current is around 30 ma with the cutoff
bias applied which is normal. When the amp is switched to transmit, the plate
current rises to 100ma, which is also normal. I've experimented with adjusting
the transmit bias to the recommended -4.5v but it has no effect on the problem.
The problem arises when I apply even the slightest level of drive to the amp.
The least amount of drive causes the plate current to rise to almost 500ma or
higher with very little output power. The tune and load controls seem to have
no effect on the plate current. I've tried the amp on all 5 bands and the
problem is the same on each band. I'm driving the amp with a Kenwood TS 530
(tube output). I suspect the swinging choke may be bad, but I'm not sure how to
test or verify it. Any ideas from anyone who has experience with this amp
would be much appreciated. Eddie KJ4R
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|