This is an excellent point! Thank you Bill.
Rudy N2WQ
--- On Wed, 8/18/10, Bill, W6WRT <dezrat1242@yahoo.com> wrote:
From: Bill, W6WRT <dezrat1242@yahoo.com>
Subject: Re: [Amps] Can I cool too much the tubes?
To: amps@contesting.com
Date: Wednesday, August 18, 2010, 2:29 PM
ORIGINAL MESSAGE:
On Wed, 18 Aug 2010 10:34:58 -0700 (PDT), Rudy Bakalov
<r_bakalov@yahoo.com> wrote:
>Experience trumps specs. The amp goes into standby mode after about 30 minutes
>running at full power, i.e. about 1200 W. If I run it at around 400-500 W it
>is fine.
REPLY:
If it were mine, I would measure the tube seal temps when it goes into
standby. It could be that Ten-Tec has been ultra conservative on it's
shutdown point.
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|