Plate resistance equals VDC/(k*Ia), with k=1.8 for AB2 GG, is this
correct?.
Best regards
Guillermo - LU8EYW.
Phil Clements escribió:
> Amen, "R"! I think that so many guys over the years used whatever they had
> in their junk boxes that looked big enough that a proliferation took place.
> Sort of like parasitic suppressers...if they worked fine on tube type A they
> should work okay on tube type B.
>
> A typical amp running max. smoke from a pair of 3-500Z's or a single 8877
> works out to a plate resistance of around 2200 ohms or so. Plugging in the
> formula, 5% of this means we need a capacitive reactance in our C/Block of
> around 110 ohms @ 1.8 mhz. Your understanding of 200 pf is enough is
> correct, as a 200 pf capacitor would have a reactance of around 440 ohms on
> 160 meters. At a lower plate load impedance, say 1000 ohms, you have even
> more headroom. You would have to exceed 8000 ohms plate load impedance to
> get even close to exceeding the 5% requirement with a 200 pf cap.
>
> (((73)))
> Phil Clements, K5PC
>
>
>
>
>
>
> Subject: Re: [Amps] DC Blocking Capacitor
>
> The value of the DC blocking cap is seeming less critical than is
> commonly thought. As I understand it, in most HF amplifiers, 200pF is
> enough. However, the I-handling ability become important on the 28MHz
> band since most of the tank circulating-current passes through the DC
> blocker on its way to and from the anode..
>
> On Apr 26, 2005, at 12:26 PM, Bob Easterbrooks wrote:
>
>
>>Gentleman, What determines the capacitive value of the DC blocking
>>capacitor
>>used in a convential shunt fed PI, and can the same rules apply to a
>>simple
>>link coupled tank circuit? I thank you in advance. Bob, K6JQA
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|