Amps
[Top] [All Lists]

Re: [Amps] Henry 2KD-5 Problem

To: "Jim W7RY" <w7ry@inbox.com>, "ED MCKIE" <kb5gt@cableone.net>, <amps@contesting.com>
Subject: Re: [Amps] Henry 2KD-5 Problem
From: "Mitch Cox" <ww4cox@embarqmail.com>
Date: Thu, 26 May 2011 18:55:47 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Since the grids are grounded to the chassis most likely got a meter shunt 
resistor or 2.
  ----- Original Message ----- 
  From: Jim W7RY 
  To: Mitch Cox ; ED MCKIE ; amps@contesting.com 
  Sent: Thursday, May 26, 2011 6:42 PM
  Subject: Re: [Amps] Henry 2KD-5 Problem


  Agreed!

  But you can't just pull one tube at a time because the filaments are in 
  series. You most likely have other parts destroyed by the tube short.


  73
  Jim W7RY



  --------------------------------------------------
  From: "Mitch Cox" <ww4cox@embarqmail.com>
  Sent: Thursday, May 26, 2011 3:32 PM
  To: "ED MCKIE" <kb5gt@cableone.net>; <amps@contesting.com>
  Subject: Re: [Amps] Henry 2KD-5 Problem

  > You have a shorted tube.
  >  ----- Original Message ----- 
  >  From: ED MCKIE
  >  To: amps@contesting.com
  >  Sent: Thursday, May 26, 2011 6:18 PM
  >  Subject: [Amps] Henry 2KD-5 Problem
  >
  >
  >  Last night I was using my 2KD-5, and it was working fine. After making
  >  several transmissions with no problem, it made a loud pop when keyed. Now
  >  the grid current indication goes off scale in the negative direction as 
  > soon
  >  as it is turned on, and stays there even with drive applied. It also has
  >  plate current flowing ( about 300 mA ) even when not keyed. It is still
  >  working and has output.
  >   I have to get someone to move it to my workbench due to a back injury, 
  > so
  >  all I've done so far is to remove the top. The bias diode reads 13.5 Kohm 
  > in
  >  both directions when checked with one end of the 220 Ohm parallel 
  > resistor
  >  lifted, but I see nothing that made the loud pop, so far.
  >   When I get it on the bench I can get into it, but wondered if anyone 
  > else
  >  had seen these problems in this or a similar amplifier.
  >  Thanks & 73,
  >  Ed,  KB5GT
  >  _______________________________________________
  >  Amps mailing list
  >  Amps@contesting.com
  >  http://lists.contesting.com/mailman/listinfo/amps
  >
  >
  >  -----
  >  No virus found in this message.
  >  Checked by AVG - www.avg.com
  >  Version: 10.0.1375 / Virus Database: 1509/3660 - Release Date: 05/25/11
  > _______________________________________________
  > Amps mailing list
  > Amps@contesting.com
  > http://lists.contesting.com/mailman/listinfo/amps
  >
  >
  >
  > -----
  > No virus found in this message.
  > Checked by AVG - www.avg.com
  > Version: 10.0.1375 / Virus Database: 1509/3662 - Release Date: 05/26/11
  > 


  -----
  No virus found in this message.
  Checked by AVG - www.avg.com
  Version: 10.0.1375 / Virus Database: 1509/3660 - Release Date: 05/25/11
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>