Contact Jeff W8CQ at w8cqjeff@ameritech.net and ask him, he's a good amp
man and in fact, he's got a clipperton-L now that he's restoring, he should
be able to help you...
73
At 04:01 PM 12/16/00 -0600, you wrote:
>
>I have just acquired a Clipperton-L, and have a minor problem, and would
>appreciate some (more) hand-holding, as I check it out.
>
>As I trace the wiring (input) according to the factory Mod instructions, it
>seems that the 10M mod was only partly done. The filter board (labelled
>FL-1) is still in place, and is still wired in. My impression is that the
>filter is to 'block' any signal in the 'naughty' range, and much of the
>Mods is just taking it out. Am I right?
>
>Can anyone confirm the reason for the existance of FL-1?
>
>The parts of the Mod that are physically more tedious seem to have been
>done. (These are the removal of the Tank and switch enough that the switch
>stop can be re-set).
>
>Any clues anyone can give me will be appreciated. Several of the group have
>been VERY helpful, already, including one OM who copied the whole manual
>(and Mod instructions) and emailed them to me.
>
>Bill-W4BSG
>
>
>-
>Bill Aycock --- Persimmon Hill
> Woodville, Alabama, US 35776
> (in the N.E. corner of the State)
> W4BSG -- Grid EM64vr
> baycock@HiWAAY.net
> w4bsg@arrl.net
>
>--
>FAQ on WWW: http://www.contesting.com/FAQ/amps
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>
>
-Chuck K8CPA
http://www.qsl.net/k8cpa -- My WebPage
http://multi.mode.listbot.com -- Digital Amateur Comm.. Mailing list
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|