At 09:59 AM 9-11-98 -0600, Richard W. Ehrhorn wrote:
>
>Hello Phil,
>
>ALPHA amps built before the FCC power limit was changed (about 1977-78)
>were designed for convenient "1 kW dc INPUT". That old rule, in effect
>since the CW & AM 30's, was ambiguous and about 90% misunderstood when
>applied to SSB. But it translated roughly into something like 2.5+/- kW PEP
>dc plate INPUT, taking SSB duty cycle into account.
>
>So the amps' HI or SSB position provides plate voltage appropriate for good
>linearity and efficiency at ~2.5 kW PEP dc input, which corresponds to
>about 1.5 kW PEP RF OUTPUT, which the post-1977 rules specify.
>
>The LO or CW position delivers a lower dc plate voltage which is optimized
>for 1.0 kW dc input on CW (as the old rules allowed). Also, the design is
>such that when the older amp is tuned properly for CW in the LO position,
>just switching to HI (SSB) sets it up for efficient SSB at 2+ kW PEP
>without any further tune/load adjustments [i.e., both conditions require
>approximately the same plate load resistance for the tube(s)].
Dick, So does this mean that one SHOULD NOT run older amps in the SSB/HI
position while operating CW mode? I'm still a bit unclear on this after
following this thread. I have been doing just that. OOPS?
73, Matt--K7BG
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|