Hi David,
Good evening.
I'm new to vacuum tube linear amplifiers, so is the SB220 difficult to
use?
I can replace the capacitors as maintenance. However, I don't think I
have the technical skills to handle the various measures to prevent
flash-overs or the installation of gas discharge tubes.
Kouichi Ueno JI1FGX/DU9
On Wed, 9 Oct 2024 13:58:34 +0000
David G4FTC <g4ftc@hotmail.com> wrote:
> I would be cautious about using zeners - from my experience their failure
> mode is to go short circuit which necessitates taking the amp apart to
> replace them.
>
> Sometime ago I wanted to ensure that a tetrode amp I was building was
> protected from Anode-Screen flashovers which could damage the screen
> decoupling capacitor built into the tube base.
>
> I used a combination of Varistors in parallel with a Gas tubes (Spark Gaps).
> The logic being that the Varistor was fast but of limited dissipation and
> provided the initial clamping action whereas the slower spark gap which could
> sustain much higher current then provided the longer term clamping until the
> HT crowbar operated and the reservoir capacitors discharged. The Varistors
> were of a slightly higher voltage than the Gas Tubes. The crowbar circuit
> also tripped the screen supply.
>
> I have experienced flash-overs but so far never lost a tube or a tube base.
> All I have to do after a trip is to press a reset button and the HT and
> screen supplies are restored and the amp is operational.
>
> David G4FTC
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|