If you think that the base of the 8877 doesn't get hot from the filament
just leave the filament on for a few minutes with no air. Then pull the tube
out of the socket and grab the base. Have some burn cream handy!
73
Gary K4FMX
> Why would the filament heat be concentrated at the socket pins? If that
> were the case, then the filament itself wouldn't be getting hot, which
> would mean that there would be no electron emission and the tube
> wouldn't
> work.
>
> If you're thinking that the socket pins will get hot from ohmic heating,
> then you're postulating high-resistance connections between the pins and
> the socket contacts, which would be A Very Bad Thing.
>
> I think that the filament is going to heat the grid and plate the most,
> by
> radiation, because it's closest to them, while there will be less
> heating
> by conduction down the filament connections to the tube base and through
> it
> to other parts of the tube.
>
> --
> Mike Andrews, W5EGO
> mikea@mikea.ath.cx
> Tired old sysadmin
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|