I THINK YOU DUDES ARE MISSING THE FOREST>>>>>>>>>>>
The purpose of the SHORTING STICK is to KILL THE HIGH VOLTAGE INSTEAD OF YOU!
The shorting stick will only damage something is it has already failed or left
been left on
BY ACCIDENT.
ie A bleeder that goes open with no warning. a plate supply powered ,and you
forgot to turn it off etc......It protects you. so what if something dies on
the power supply>>> You didn't<<
You also don't want any other resistors,bleeders,relays or any other junk
connected to the shorting stick. just a hook ,10 gage wire and a alligator
clip to ground, stick should be about a foot and a half long.
The habit of hooking the shorting stick on the hv line may save your relatives
pain,and your life,but only if you do it as practice each and every time!
First thing done. Last thing removed
john kb9tc
Will Matney <craxd1@ezwv.com> wrote:
Perzactly! My reasoning on the discharger was to allow the caps to discharge
through some resistance at first to limit the current, and after a short time,
say 2 seconds, a dead short by a relay would finish it off. To me, the quick
discharge of a capacitor is really hard on it and can ruining the dialectric.
Another thing I dont trust are those safety latches on most amps which mostly
short the caps to ground if the lid is opened. Lets say the contact was made
once under a full charge, or worse, while the amp was running. Then an arc
would burn the contact surface maybe to a complete open. This then could make a
high resistance there or even make it fail in the future to where it wouldn't
discharge them at all. Next, some poor un-assuming soul went ahead and put his
hands on a fully charged capacitor bank (providing the resistors was bad).
One rule I always do on a charged capacitor bank or a running amp is to keep
one hand behind my back and use the other to do any measurements. This way if I
slip, the worse case would be to just get it maybe from a finger to the wrist,
across the fingers, etc., and not through my body. Just that shock to the hand
is enough to knock the dickens outta ya really quick! One trough the body
though could stop your heart! I've been bit before it it sure aint no fun.......
Best,
Will
*********** REPLY SEPARATOR ***********
On 4/24/05 at 10:20 AM R@contesting.com;Measures wrote:
>A 0½ (zero-ohm) shorting stick can damage an amplifier since there is
>virtually nothing to limit peak discharge current. If a 1000-ohm or
>so, 100 to 225 watt resistor is added in series with the shorting stick
>to limit current, there is less chance of damage.
>
>
>Rich Measures, 805.386.3734, AG6K, www.somis.org
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com _______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|