Amps
[Top] [All Lists]

[AMPS] Practical PI Nets

To: <amps@contesting.com>
Subject: [AMPS] Practical PI Nets
From: 2@vc.net (measures)
Date: Tue, 2 May 2000 07:29:16 -0700
>In a message dated 5/2/00 9:00:59 AM Eastern Daylight Time, 2@vc.net writes:
>>  
>>  >
>>  >One not too expensive device is the Almost All Digital Electronics L-C
>>  >meter. It's cheap, pretty accurate, and comes as a kit that took me under 
>> an
>>  >hour to build. It is worth changing the 5 volt regulator to a low drop out
>>  >type, though, as you get a lot more effective battery life.
>>  >
>>  >Of course, it doesn't measure at the operating frequency, 
>>  
>>  The apparent resonant frequency of two L networks in series is not the 
>>  operating frequency.  
>>  
>>  cheers, Peter
>>  
>>  -  Rich..., 805.386.3734, www.vcnet.com/measures.  
>>  end
>>  
>--------------------------------------------------------------------------
>----
>-
>Rich,
>
>Could you give an approximation to guesstimate the difference in the 
>apparent 
>measured frequency and the operating frequency?  

As I recall, on 80m the difference is typically hundreds of kilohertz, 
with the resonance of the tank being lower than the operating frequency 
where the tank was adjusted.  

> Or what factors determine 
>the difference ?
>
The biggest factor is Q.  The higher the Q, the less the difference.  

later, Dave

-  Rich..., 805.386.3734, www.vcnet.com/measures.  
end


--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>