Thanks Carl:
If I don't decide to get a KPA1500, i'll consider that modification. If the amp
were here, I'd send it to Richard Byrd for modification. But it's in Mali.
What all would be entailed? Also the 3CX/3CPX800A7 alone is about $1200.
With kind regards,
Jeff
-----Original Message-----
From: Carl <km1h@jeremy.qozzy.com>
To: tz4am <tz4am@aol.com>; LDighera <LDighera@att.net>; Amps
<Amps@contesting.com>
Sent: Tue, Oct 16, 2018 9:20 pm
Subject: Re: [Amps] KPA1500 in QSK mode
A single 3CX/3CPX800A7 will replace a pair of 8874's and is almost a plug in
swap.You will need a new filament transformer.
https://frank.pocnet.net/sheets/140/3/3CX800A7.pdf
Carl
----- Original Message -----
From: "Jeff Dorsey via Amps" <amps@contesting.com>
To: <LDighera@att.net>; <Amps@contesting.com>
Sent: Monday, October 15, 2018 7:19 PM
Subject: Re: [Amps] KPA1500 in QSK mode
> Larry:
> The 76a is not modified so it needs 8874s as far as I know. And I have not
> succeeded in finding any good ones.
> Are the tubes you suggest direct substitutes for the 8874s?
>
> I am leaning toward buying a KPA1500 which would have many advantages for
> me and the way I operate in Mali.
> With kind regards,
> Jeff
>
> -----Original Message-----
> From: Larry Dighera <LDighera@att.net>
> To: Amps <Amps@contesting.com>
> Sent: Sun, Oct 14, 2018 5:18 pm
> Subject: Re: [Amps] KPA1500 in QSK mode
>
>
>
> Hello Jeff,
>
> Tubes are an issue for the 87A as well; that's for sure. Here are
> some tubes to consider:
>
> NEW GS-36B/4CX400A Tube, Tetrode, Russian
> https://www.rfparts.com/catalogsearch/result/?q=GS-36B $174.95/each.
>
> New old stock GS-36B tetrode
> https://www.ebay.com/itm/263803841869 US $49.00/each.
>
> Hope that helps return your venerable 76A to operational status.
>
> Best regards,
> Larry
>
>
> On Sun, 14 Oct 2018 01:36:33 +0000 (UTC), <tz4am@aol.com> wrote:
>
>>Larry:
>>I have an Alpha 76A but have never succeeded in getting a good set of
>>tubes for it.
>>I like the KPA1500 but am hesitating for the same reason: price
>>Instant-on and 6 meters are a big draw for me too.
>>73,
>>JeffTZ4AM/K1MMB
>>
>>
>>-----Original Message-----
>>From: Larry Dighera <LDighera@att.net>
>>To: Amps <Amps@contesting.com>
>>Sent: Fri, Oct 12, 2018 12:00 pm
>>Subject: Re: [Amps] KPA1500 in QSK mode
>>
>>
>>Hello Bob,
>>
>>I've been considering replacing my Alpha 87A
>><http://kj6yvt.com/amplifier.htm> with an Elecraft KPA1500 too. The
>>instant-on feature solid-state amplifiers offer is attractive to a
>>fellow who hates to wait, and the 6 meter support and built-in antenna
>>tuner are what have lead me to this. The KPA1500's $5,995.00 price
>>tag is about double what I paid for my used 87A, and my 87A is
>>integrated with the Alpha DAS antenna selector relay control box, so
>>I'm still on the fence.
>>
>>Thank you for posting the Alpha 87A memory dump procedure
>><https://www.kkn.net/~n6tv/Alpha_87A_Memory_Dump.pdf>. That is
>>something all 87A owners will appreciate.
>>
>>And I very much enjoyed your extensive 2018 Visalia International DX
>>Convention photo album <https://bit.ly/Visalia2018>.
>>
>>Best regards,
>>Larry Dighera
>>WB6BBB
>>
>>
>>On Tue, 9 Oct 2018 23:45:07 -0700, "Bob Wilson, N6TV" <n6tv@arrl.net>
>>wrote:
>>
>>>Mickey,
>>>
>>>I just used a pair of KPA1500s in the California QSO Party, full bore, CW
>>>only, for 24 hours. The performance was solid, no glitches. QSK was
>>>silent and fast, so it's safe to use a K3 transceiver in CW QRQ mode
>>>(about
>>>4.3 ms PTT to RF delay, maximum QSK performance). Fan noise was not a
>>>problem while wearing David Clark headphones. I manually set the fan
>>>level
>>>to a minimum value of 2 (out of 5) which is pretty loud, but it kept the
>>>temperature below 62°C, so the amp. never kicked into a higher fan speed.
>>>I'm running a beta version of the firmware (1.78).
>>>
>>>Though I use two K3s, the KPA1500 amp/tuner combo. can automatically
>>>track
>>>your 6600M frequency (see the USB Cables section in the Flex Manual). You
>>>can use the XCVR SERIAL port on the KPA1500 for this. The S-BOX
>>><https://bit.ly/S-BOX> makes that connection easy using standard serial
>>>and
>>>TRS cables, no custom cables required. (The S-BOX can also do this for
>>>SPE
>>>and ACOM amps).
>>>
>>>My Alpha 87As are now for sale.
>>>
>>>73,
>>>Bob, N6TV
>>>
>>>On Mon, Oct 8, 2018 at 5:28 AM Mickey Baker <n4mb@arrl.net> wrote:
>>>
>>>> I have a fairly new 6600M and once had the PowerGenius on order, but
>>>> cancelled after it was delayed and my transceiver was ready.
>>>>
>>>> I'm thinking that the Elecraft KPA1500 is the only full power solid
>>>> state
>>>> amp with qsk that can replace my AL1500 with QSK5.
>>>>
>>>> Thoughts from the group?
>>>>
>>>> Mickey Baker, N4MB
>>>> Fort Lauderdale, FL
>>>> *“Tell me, and I will listen. Show me, and I will understand. Involve
>>>> me,
>>>> and I will learn.” *Teton Lakota, American Indian Saying.
>>>>
>>>_______________________________________________
>>>Amps mailing list
>>>Amps@contesting.com
>>>http://lists.contesting.com/mailman/listinfo/amps
>>_______________________________________________
>>Amps mailing list
>>Amps@contesting.com
>>http://lists.contesting.com/mailman/listinfo/amps
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
---
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|