Amps
[Top] [All Lists]

Re: [Amps] QSK5-PC in a AL1200

To: "Ed Swiderski, KU4BP" <ku4bp@triad.rr.com>, <Amps@contesting.com>
Subject: Re: [Amps] QSK5-PC in a AL1200
From: gudguyham--- via Amps <amps@contesting.com>
Reply-to: "gudguyham@aol.com" <gudguyham@aol.com>
Date: Sat, 13 Jan 2024 19:55:16 +0000 (UTC)
List-post: <mailto:amps@contesting.com>
FWIW….I’ve removed more of those boards in Ameritron amps than I installed.  
It’s not if, but when you have trouble with it.  The diodes are no longer 
available and they are so expensive!!


Sent from the all new AOL app for iOS


On Saturday, January 13, 2024, 1:04 PM, Ed Swiderski, KU4BP 
<ku4bp@triad.rr.com> wrote:

Hello all,

As the subject line says, I have an issue with the QSK5-PC board in my 
AL1200. The QSK5 board has been blowing it's fuse lamps. I think I've 
replaced them 3 times in the past 12 months.

I haven't been doing anything abnormal with the board in the years I've 
had the amp. It was already installed when I purchased it in 2009. Never 
had any issues with it and I have only used it with SSB. The only time I 
use CW with it has been to tune it up in a dummy load with a straight 
key. A couple times during normal use in SSB, the fuse lamps on the 
board would blow. The latest use had the lamps blow while tweaking my 
settings on the amp.

I contacted Ameritron for advice. They told me to "try operating in semi 
break mode and increase the delay speed and see if that clears it up". I 
did that but since I'm not operating CW in the first place, it didn't 
help. Ameritron also said the board may have a bad PIN diode. I haven't 
removed any of them to check. I think it's possible because the board 
was installed in 1994(30 years).

So, I'm asking first if anyone has had a similar issue that can give any 
advice. Second, I'm toying with either getting a new board or, just 
undoing the modification altogether. Doing either is not a problem. I 
would like to keep the mod in place though which is why I'm indecisive 
right now. Hope to get the amp back in use by the end of this year for 
when 3Y0/B is planned to come on.

I hope I have given enough information. When I first had this problem 
last year, I didn't provide enough information and I think I upset a 
couple people by not doing so and I apologize for that.

Will try to respond to replies promptly.

Thank you,
Ed KU4BP
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>