At the moment I assume I have RF to the tube as I did not disconnect any of
the
wires from input connector to the tube but I will need to verify, The output
network
connections from the plate blocking capacitor to the output connector were
not
disconnected at any time. There is continuity from the output connector back
to the
plate blocking capacitor.
I did have plate current (~350mA) at one point but no output. I need to
re-verify
the plate current because most of the time it appears to be very little
current.
Thanks to all who have provided suggestions.
73, Larry W6NWS
----- Original Message -----
From: "Ron Youvan" <ka4inm@tampabay.rr.com>
To: "Larry" <w6nws@arrl.net>
Sent: Sunday, October 31, 2010 10:17 AM
Subject: Re: [Amps] Suggestions - I broke my amp
> Larry wrote:
>
>> I am looking for suggestions regarding my Clipperton-L. The basic problem
>> is that there is
>> no output. No apparent plate current.
>
> Do you have any plate current, with a VOM or other ammeter from
> filament/cathode to ground?
> Do you have RF to the tube, at the tube?
> --
> Ron KA4INM - nothin's quite as sure as change
> from "look through my window" - The Mamas & The Papas
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|