For an input SWR when using a solid state amplifier against a PT2500 Amplifier,
why not use something like this? It will provide a 50hom load to the
transceiver input regardless of the band exercised. They offer 1db, 2db on up
of attenuation, and are matched at 50ohms to the Transceiver input of the amp
all the way to 1Ghz or better. The point being here the transceiver will always
see a ~50ohm load. Just a thought.
https://www.ebay.com/itm/370603866564?hash=item5649b639c4:g:s2sAAOSwLzdWRTy4
Thank you,
Mike
W5CUL
-----Original Message-----
From: Amps <amps-bounces@contesting.com> On Behalf Of gudguyham--- via Amps
Sent: Thursday, August 25, 2022 11:48 PM
To: Bob Gibson <w5rg@yahoo.com>; amps@contesting.com
Subject: Re: [Amps] B&W PT2500
Bob, I’ve got two of these amps in my shop now. You should be aware that the
stock open frame relay is 120vdc and most radios can’t handle this switching
voltage/current. You’ll need a buffer of some sort. Personally I like
installing a soft key internally. You can use a Harbach SB220 soft key kit or
a similar one completely assembled. I have completely assembled soft key
units. Don’t try to key this amp without one! Also, be aware that this amp
does not have adjustable input networks like many other amps do. Keep in mind
that these amps were designed around being used with tube type radios with
adjustable pi-networks. Therefore the input networks only needed to be “good”
as to present an “ok” swr to a tube exciter. Using this amp with a solid state
radio you may find that the input swr is less than stellar. If it’s a bit high
for a solid state radio they will fold back and your power output will be low.
Check your input swr! If it’s poor there’s not much you can do about it except
use the radio tuner. The input circuits are buried and inaccessible. Way
before it’s time, this amp has a grid trip circuit which is factory set for
400ma. Lou
Sent from the all new AOL app for iOS
On Thursday, August 25, 2022, 11:38 PM, Bob Gibson via Amps
<amps@contesting.com> wrote:
I have bought a B&W PT2500 amplifier and I looking for blower for the unit. If
anyone happens to have a part number or where to find one..Please let me
know..Also has anyone done any kind of a mods to one..20 meter output is low..
73s Bob W5RG
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--
This email has been checked for viruses by Avast antivirus software.
www.avast.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|