At this point you need to connect a PC operating in a terminal program to
the 87A and find out what fault it was taking repeatedly. Then with that
knowledge maybe Crosslink can assist you over the phone.
Terry W6RU
----- Original Message -----
From: "James C. Hall, MD" <nwtcc@earthlink.net>
To: <amps@contesting.com>
Sent: Sunday, February 02, 2003 6:23 PM
Subject: [Amps] Help ! Hard Fault 99
> Hello:
>
> I just put my new Alpha 87A into service this W/E and had a good day
> setting up and fine tuning each band segment and making a few contacts.
> I shut down for a few hours and when I returned I could not turn the
> power back on the amp without an immediate shutdown. I tried multiple
> attempts and then finally I could not get anything to happen - the
> number of attempts 'timed-out'. I have no idea what is wrong. I
> brought it down off its shelf and popped the lid. Nothing looked out
> of sorts, no discoloration or burnt parts, etc. All three fuses looked
> and checked out fine. My primary tap is set at factory default of 240
> volts. I, according to Alpha (Crosslink), must now contact them for a
> reset code to attempt to revive my patient.
>
> Any assist comments would be welcome.
>
> Jamie
> WB4YDL
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
|